Skins
T-M Lắp đặt kim thu sét từ mái đến đỉnh kim thu sét 30m

Hãy chia sẻ cảm xúc của bạn
Đã xem: 1058 , Thảo luận: 0
Thích: 0
Không thích: 0
You may have a mechanical ground, but do you have an electrical ground?

You may have a mechanical ground, but do you have an electrical ground?

The lightning rod is clamped to the highest point on the mast. The ground wire is connected to the lightning rod and should be one continuous piece all the way to the earth ground rod. A small loop is left just above the thrust bearing to allow the mast to rotate. If you cannot use a lightning rod point because of the antenna, tape or wire tie the ground wire to the mast as far up as practical. This will provide some lightning protection to other components such as rotators, antennas, etc. When using a Hazer, the ground wire runs down the messenger line, and into the ground rod system. This can provide the electrical ground required for long wire antennas. With rooftop towers, the ground wire should run from the tip of the mast, be connected to the tower, and then run all the way to the ground. Grounding the tower cannot be over stressed. Local or national codes should be complied with. The head of the ground rod should be driven at least 6 inches below ground level and the ground wire should be attached  with two GR-4400 ground rod clamps. Ground your system to achieve a goal of 25 ohms or less ground resistance. Additional ground rods may be necessary to accomplish this. The ground cable, 4 AWG by 19 strand bare copper is very flexible and is ordered separately. It is advisable to consult with an experienced lightning professional for installation.

Phát video-clip: 135816/04/2013
Giới thiệu thiết Bị chống sét Australia
Phát video-clip: 102816/04/2013
Hướng dẫn hàn hóa nhiệt exoweld
Phát video-clip: 124116/04/2013
Hướng Dẫn xử lý đầu cáp thoát sét chống nhiễu LPI Australia.
Phát video-clip: 133314/04/2013
Nguyên lý cơ bản của hệ thống chống sét trực tiếp
Nhận xét về video-clip
Bạn cần đăng nhập để viết bình luận. Nếu chưa phải là thành viên, xin vui lòng đăng ký.